User's Manual

8
Fig. 4 Fig. 5
 Remove the protective film from the adhesive on the Ferma-flex clip (Fig. 4)
 Position the plastic Ferma-flex clip as shown in figure 5
 Before you install the B1 system on the helmet, make sure it turns on properly. Press
the “on” key for about 2 seconds, until the LED lights up and you hear a beep in the
headset. Proceed with the installation.
 Remove the cheek padding (see helmet instructions).
Fig. 6
 Remove the helmet edge gasket using
the special tool (Fig. 6).
 Remove the “N-Com” plugs found at
the back of the shell gasket and on
the left side of the helmet (Fig. 6).
Fig. 7
 Completely remove the gasket as
shown in Fig. 7; by doing so you also
remove the padding.