User's Manual

42
The position of the pointer on the bar is affected by end point values (throttle and
b rake ) an d t rim se t t in g ; in cre asin g t he t h rot t le en d p o int valu e m ay visu ally ap p e ar t o
have the same effect as decreasing the brake end point value.
Adju st ing t he Throt t le End Point
T he t h rot t le en d po int valu e is a relat ive valu e , an d is e xp re sse d as t he pe rce nt age of fu ll
travel to the THROTTLE end. For example, setting the thrott le end point value to “50” allows
the throttle to go to only 50% of full travel to the throttle end.
Use the navigation controls to adjust the throttle end point as follows:
1. A ccess the to p fun ction men u fr o m
the d r iv ing scr een .
me nu
2. Nav ig ate to th e Throttle ( Ch2)
menu.
or : then
3. Nav ig ate to Thr ottle End Point.
or
Value Descr iption
0 Min imu m throttle en d p o in t; allo w s NO th ro ttle.
1- 99
Thro ttle en d p o in t v alu e is set to a per centag e
of fu ll thr o ttle tr av el.
For example, a v alu e of “ 50” giv es 50% full
th r o ttle trav el.
4. Ch ange th e v alue.
or
100
Maximum th r o ttle end poin t; allo w s FULL
th r o ttle trav el.
Trim and EPA I nt eract ion
A trim ( o r sub - trim) settin g of 10 0 i s eq u iv alen t to an End Po in t settin g of 20.
Thrott le Servo Reverse
T hrott le servo reversing
reverses t he direct ion t he
t hrott le servo moves upon
rece ivin g an in p u t f ro m t h e
throttle trigger.