User's Manual

48
Ch an g in g t he du al rat e set t in g h as t h e f o llo w in g visu al e f f e ct on t he d rivin g scre en b ars:
Full ser vo r ange is used .
Lower dual rate value reduces servo range.
Adju st ing Shift Servo Dual Rat e
Use the navigation controls to adjust shift servo dual rate as follows:
1. A ccess the to p fun ction men u
fr om the d r iv ing screen.
me nu
2. Nav ig ate to th e Shift ( Ch3 )
menu.
or : then
3. Nav ig ate to Dual Rate.
or
Value Descr iption
0 Sh ift ser v o r an g e is set to min imu m ( 0% ) .
1- 99
Sh ift ser v o r an g e is set to a per cen tage of full r an g e.
For examp le, v alu e “ 50” giv es 5 0% of fu ll ser v o
range.
4. Ch ange th e v alue.
or
100 Sh ift ser v o r an g e is set to fu ll ( 10 0% )
Dual Rate and End Point Adjust ment
Full se rvo ran g e is d et e rmin ed b y t he sh if t se rvo low and h ig h e nd po in t adj u st me nt s. Th e d u al
rate value determines the relative servo range between the low and high end points. The
se rvo w ill n e ve r m o ve beyon d t h e set e nd po in t ad ju st me nt s, no m at t e r w h at d u al rat e set t in g
is applied.
Low End Point
T he sh ift se rvo lo w en d po int
value adjust s t he shift servo’s
st art ing posit ion at reset . This is
in t en de d t o be low g e ar an d
goes w it h the downshift sound
event . The end point
adjust ment s should be adjust ed
prior t o ot her sett ings.
T he low e nd po in t is se t
independently of the high end
point (w hich adjust s how far
t he shift servo moves t o the
HIGH end).