User's Manual

51
The position of the pointer on the bar is affected by end point settings (low
and high) and t rim set t ing; in creasin g t h e hig h end point value may visually
appear t o have the same effect as decreasing the low end point value.
Ad just ing t he High End Point
The high end point value is a relat ive value, and is expressed as the percentage of full travel
to the HIGH end. For example, setting the high end point value to “50” allows the servo to
move only 50% of full travel to the high end.
Use the navigation controls to adjust the high end point as follows:
1. A ccess the to p fun ction men u
fr om the d r iv ing screen.
me nu
2. Nav ig ate to th e Shift ( Ch3)
menu.
or : then
3. Nav ig ate to High End Poin t.
or
Value Descr iption
0
Minimum high end point; allows NO travel to high
end.
1- 99
High end point value is set to a percentage of
trav el range to high en d.
For example, a v alu e of “ 50” giv es 50% of full
tr av el to h ig h end .
4. Ch ange th e v alue.
or
100
Maximum h ig h en d po in t; allo w s FULL tr av el to
high end.
Trim and EPA I nt eract ion
A trim ( o r sub - trim) settin g of 10 0 i s eq u iv alen t to an End Po in t settin g of 20.