User's Manual

26
Changing the left end point value has the following visual effect on the driving screen bars.
Left end point value is approximately the same as the right end point
value.
Increased left end point value (more servo travel to the left is possible).
Decreased left end point value (less servo travel to the left is possible).
The position of the pointer on the bar is affected by the steering end point settings (left
and right) and trim setting; increasing the left end point value may visually appear to
have the same effect as decreasing the right end point value.
Adjusting the Left End Point
The left end point value is a relative value, and is expressed as the percentage of full travel to
the left. For example, setting the left end point value to “50” allows the steering servo to turn
only 50% of full travel to the left.
Use the navigation controls to adjust the left end point as follows:
1. Access the top function menu from
the driving screen.
men
u
2. Navigate to the Steering (Ch1)
menu.
or : then
3. Navigate to Left End Point.
or
Value Description
0
Minimum left end point; allows NO turning
motion to the left.
1-99
Left end point value is set to a percentage of
full left-turning range. For example, a value of
“50” gives 50% of full left-turning range.
4. Change the value.
or
100
Maximum left end point; allows FULL left-
turning range.
Trim and EPA I nteraction
A trim (or sub-trim) setting of 100 is equivalent to an End Point setting of 20.