User's Manual

55
Note that in 4WS or Thr/ Brake mode the settings on this screen (End Points, Dual Rate, Trim,
Reverse, Type, and Servo Speed) still take effect. The Expo setting from the master channel is
used, for Thr/ Brake Auto Start, I dle Up, and ABS apply.
Ch3 Speed
Ch3 speed allows you to limit the maximum speed that
the shift servo will be driven to match your movements
on the button. There are four parameters that can be
adjusted to precisely set up your limiting.
Input/ Throttle Speed determines the percentage of full
speed that is applied to the throttle movements that are
above the throttle trigger setting. 100 is maximum servo
movement rate. 1 is minimum rate. Default is 100 (full
speed)
Return/ Brake Speed determines the percentage of full
speed that is applied to braking movements that are
above the trigger setting. 100 is maximum servo
movement rate. 1 is minimum rate. Default is 100 (full
speed)
Trigger sets the minimum amount of control input before
the speed limiter becomes active. At 0% , limiting is
always active (input is always > = 0% ). At 50% , limiting
is only active if the throttle is half way or more.
Brake Trigger sets the minimum amount of control input
before the speed limiter becomes active. At 0% , limiting
is always active (input is always > = 0% ). At 50% ,
limiting is only active if the brake is half way or more.
The parameters of this function operate differently depending on which mode CH3 is currently
set for. (See Shift Servo Mode above).
Shift Servo mode set for 4WS Shift Servo mode set for Thr/ Brake
Input/ Throttle Speed acts as I nput Speed
Return/ Brake Speed acts as Return Speed
Trigger acts as Trigger
Brake Trigger is not used
Input/ Throttle Speed is Throttle Speed
Return/ Brake Speed acts as Brake Speed
Trigger acts as Throttle Trigger
Brake Trigger acts as Brake Trigger