User's Manual

Appendix A: Transmitter Test Mode
The transmitter has basic test code built into the application, mainly for checking the front panel
connections. See Transmitter Setup for instructions on entering Test Mode.
During the test procedure, any LED that is not specifically stated as being illuminated will flash
briefly once per second. This is to make it clear that you are not in a normal operating mode. The
RELEASE button is used to step through the test, implicitly testing it in the process. The sequence
is:
1.BIND Test
oIlluminate all front panel LEDs until RELEASE is not pressed.
oLINK LED on whenever BIND is pressed
oTest ends when RELEASE is pressed
2.Speed Switch Test
oIlluminate all front panel LEDs until RELEASE is not pressed.
oRX LED on when Speed is HIGH
oTX LED on when Speed is MEDIUM
oLINK LED on when Speed is LOW
oTest ends when RELEASE is pressed
3.Steering Test
oIlluminate all front panel LEDs until RELEASE is not pressed.
oRX LED on when stick is full right
oTX LED on when stick is centered
oLINK LED on when stick is full left
oTest ends when RELEASE is pressed
4.Throttle Test
oIlluminate all front panel LEDs until RELEASE is not pressed.
oRX LED on when stick is full forward
oTX LED on when stick is centered
oLINK LED on when stick is full back
oTest ends when RELEASE is pressed
5.Pan Test
oIlluminate all front panel LEDs until RELEASE is not pressed.
oRX LED on when knob is full right
oTX LED on when knob is centered
oLINK LED on when knob is full left
oTest ends when RELEASE is pressed
6.Tilt Test
oAs for Pan Test
7.Steering Trim Test
oAs for Pan Test
8.Throttle Trim Test
Page 14