User's Manual

A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 50.
Steering Left End Point
The steering left end point value
adjusts how far the steering
servo turns to the LEFT with
respect to its full range of motion
to the left. End point adjustment
should be adjusted prior to other
steering settings, as the left end
point value affects other steering
settings.
The left end point is set independently of the right end point (which adjusts how far the steering servo
turns to the RIGHT). The left end point setting should be used to do the following:
Limit steering throw to reduce mechanical binding or servo strain that may occur on full servo throw to
the left. For example, if the servo is trying to turn the steering system to the left farther than it is
mechanically able.
Adjust steering throw to change steering characteristics when turning to the left.
For example, if the current amount of steering throw to the left causes oversteer or understeer when
turning to the left.
Steering (Ch1)
Throttle (Ch2)
Shift (Ch3)
Ch4
Left End Point
On the driving screen, the left end point is
represented by the length of the bar to the left of
the pointer on the upper bar.
The greater the left length of the bar, the greater
the left end point value.
The position of the pointer on the bar is affected