User's Manual

Right end point value is approximately the same
as the left end point value.
Increased right end point value (more servo travel
to right is possible).
Decreased right end point value (less servo travel
to right is possible).
The position of the pointer on the bar is affected by the steering end point values (left and right) and
trim setting; increasing the right end point value may visually appear to have the same effect as
decreasing the left end point value.
An end point setting of 100 (the default) is typical for most servos, and should always be used for
ESCs. Larger setting values will overdrive most servos
Use the navigation controls to adjust the right end point as follows:
1. Access the top function menu from the
driving screen.
2. Navigate to the Steering (Ch1) menu.
or then
3. Navigate to Right End Point.
or
Value Description
0
Minimum right end point; allows NO turning motion
to the right.
1-200
Right end point setting is set to a percentage of full
right-turning range.
4. Change the value.
or
200 Maximum right end point (will overdrive most servos)
Trim and EPA Interaction
A trim (or sub-trim) setting of 100 is equivalent to an End point setting of 50