User's Manual

The position of the pointer on the bar is affected by end point values (throttle and brake) and trim

setting; increasing the throttle end point value may visually appear to have the same effect as

decreasing the brake end point value.

An end point setting of 100 (the default) is typical for most servos, and should always be used for

ESCs. Larger setting values will overdrive most servos

Adjusting the Throttle End Point

The throttle end point value is a relative value, and is expressed as the percentage of full travel to the

THROTTLE end.

Use the navigation controls to adjust the throttle end point as follows:

1. Access the top function menu from the

driving screen.

2. Navigate to the Throttle (Ch2) menu.

or then

3. Navigate to Throttle End Point.

Value Description

0 Minimum throttle end point; allows NO throttle.

1-199

Throttle end point value is set to a percentage of full

throttle travel.

4. Change the value.

200

Maximum throttle end point (will overdrive most

servos)