Instructions / Assembly

10
M
L
L
B
Assembly — Hanging the Fan (continued)
Preparing the receiver and remote
control
6
This remote control unit is equipped with 16 code
combinations to prevent possible interference from or to
other remote units. The frequency switches on your
receiver (L) and remote control (M) have been preset at
the factory. Please recheck to make sure the switches on
the remote control (M) and the receiver (L) are set to the
same position. Any combination of settings will operate
the fan as long as the remote control (M) and receiver
(L) are set to the same position.
□
Insert the receiver (L) into the mounting bracket (B)
with the flat side of the receiver (L) facing the
ceiling.
CAUTION: Do not use with a wall light dimmer switch.
WARNING: To avoid possible electrical shock, ensure the
electricity is turned off at the main fuse box before wiring.
NOTE: If you feel you do not have enough electrical
wiring knowledge or experience, have your fan installed
by a licensed electrician.
F
NN
B
E
5
Hanging the fan motor assembly
from the mounting bracket
□
Lift the fan motor assembly (H) into position, and place the
hanger ball (E) into the mounting bracket (B). Rotate the
fan motor assembly (H) until the check groove drops into
the registration slot (NN) and seats rmly. The downrod (F)
should not rotate if this is done correctly.