Installation guide
1
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
PACKAGE CONTENTS
Low Voltage LED
Flower Light
Use and Care Guide
ITEM #909-015
MODEL #29504
Flower light head
(glass)
(A)
Post connector
(B)
Short post
(C)
Long post
(D)
Stake
(E)
Transformer
(with photocell)
(F)
Wire connector
(G)
Remote
control
(H)
TM
Attaching and installing the
light
□ Each xture can be congured to three
standard heights using the posts and
connectors that are included. The maximum
suggested height is achieved by connecting
one long post (D) and one short post (C).
□ If using more than one post, connect the
posts together using the post connector (B).
□ Route the wire from the ower light head (A)
through the post(s).
□ Attach the xture stake (E) to the post(s).
(Note that there is a notch on one side of
the stake to allow the xture’s wire to exit
without pinching.)
□ Grasping the base of the post only (do not
use the glass ower light head (A)), gently
push the stake into the ground.
1
IMPORTANT: Protect the wiring by routing it in
close proximity to the light, tting, or next to a
building structure such as a house or a deck.
IMPORTANT: Do not bury the wiring by more
than 6 inches (152mm) in order to connect to
the main secondary wire.
IMPORTANT: Do not connect two long posts (D)
together as it will result in an unstable height.
Any other combination of a single post or two
connected posts is acceptable.
IMPORTANT: Do not install the light within 10 ft.
(3 m) of a pool, spa, or fountain.
D
A
C
A
D
A
B
E
E
E
C
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
Assembly and Installation
CAUTION: Do not submerge in water. The
product can be damaged.
patent US D659, 273 S