Instructions / Assembly

Assembly — Close-to-Ceiling Mounting

Assembling the fan

Preparing the motorPreparing the canopy

□ Remove the canopy ring (B) from the canopy (C).

□ Remove the mounting bracket (A) from the canopy (C)

by loosening the four canopy mounting bracket

screws (BB) on the top of the canopy (C).

□ Remove the two non-slotted canopy mounting

bracket screws (BB) and loosen the slotted canopy

mounting bracket screws (BB).

□ Remove the canopy bottom cover (D) from the canopy

clockwise.

□ Remove three of the six collar mounting screws with

lock washers (FF) (every other one) from the collar on

top of the fan motor assembly (F).

WARNING: Failure to completely tighten the three collar

mounting screws (FF) could result in the fan becoming loose

and possibly falling.

□ Make sure the slot openings of the canopy ring (B)

are on top, and then proceed to place the rubber

gasket (II), canopy ring (B) and canopy (C) over the

collar at the top of the fan motor assembly (F).

□ Align the mounting holes in the bottom of the canopy

with the holes in the top of the fan motor assembly

(F). Fasten using the three collar mounting screws

with lock washers (FF) previously removed.

□ Tighten the collar mounting screws (FF) securely.