Installation guide

Installation of Sculpted Corner Soap Dish
If installing the sculpted corner soap dish, the optional
corner molding should be installed before the soap dish is
installed. Once the corner molding is in place, proceed
with Steps 1 through 7 of the “Installation of the Square
Corner Soap Dish” section.
The following illustrations show the sculpted corner soap
dish and the shower with the corner molding installed.
Care and Cleaning
The Swanstone products are stain and abrasion
resistant; however, the finish requires reasonable care.
Because cleaning products change over time, always
check the manufacturer’s instructions to make sure it is
compatible with solid surface acrylic. DO NOT use a
cleaner if the label indicates it should not be used on solid
surface acrylics. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to
stop the chemical cleaning reaction because damage will
result and void the warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can
be cleaned with warm water, a soft cloth, and normal
household detergents or cleansers, such as Fantastic,
Formula 409, Clorox Clean-up, Handy Andy, Mr. Clean,
Dow Scrubbing Bubbles, Lysol Foaming Tub and Tile
Cleaner, Top Job, or Lestoil. Always rinse off cleaners
within five minutes of application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs
of separation from the mating surface. Cracks in the
caulking will allow water to leak into the surrounding
surfaces. Reapply caulking to any joint showing
signs of wear or cracking. Failure to inspect and
repair caulking joints will void the warranty.
Surface Repair
Light Scratches
Use 400 grit sandpaper to remove light scratches in the
surface.
Deep Scratches or Gouges
For deeper scratches or gouges, use 220 or 320 grit
sandpaper. A “Scotchbright pad” can be used to blend
the repair into the surrounding area.
IMPORTANT NOTICE
Installation Procedure Maintenance & Surface Repair
800-325-7008 9 The Swan Corporation – Swanstone