Installation guide

Page | 4
Safety Instructions:
INSTALLATION
 FloorHeat™ heating mats should be installed only by qualified personnel who are
familiar with the construction and operation of the apparatus and the risk involved.
 The installation of this heating product shall be in accordance with the manufacturer's
instructions and the regulations of the authority having jurisdiction.
Note: Refers to US and Canada: The installation shall be made in accordance with Article 424,
Part J, of the National Electrical Code, ANSI/NFPA 70 and the applicable sections of Canadian
Electrical Code, C22.1.
HIGH VOLTAGE
Disconnect the heating mats from the power line before any adjustment. Maintenance should be
done only while heating mats are disconnected from the power source, and should only be
performed by qualified personnel.
LINE VOLTAGE
Before connecting the product to the power supply, make sure that the voltage of the power
source matches the requirements of the product, as marked on the FloorHeat™ label located
near the product's power connectors.
WIRING
 All electrical connections must be performed by a fully qualified electrician and in
accordance with each country's NEC (National Electrical Code). Make sure that all
conductor sizes are at least 14AWG.
 The connection of the cold leads must be made inside the electrical connection box.
Connect all units in parallel making sure not to exceed the current handling capacity of
the supply line.
 The heating system should be connected to its own circuit of the power supply.
IMPORTANT!
WARNING!, RISK OF ELECTRIC SHOCK AND FIRE. DAMAGE TO SUPPLY CONDUCTOR
INSULATION MAY OCCUR IF CONDUCTORS ARE ROUTED LESS THAN 50 MM (2 INCHES) FROM
THIS HEATING PRODUCT.
REFER TO INSTALLATION INSTRUCTIONS FOR RECOMMENDED MEANS OF ROUTING SUPPLY
CONDUCTORS.