User's Manual
Table Of Contents
- Guide to Symbols
- Precautions for Use
- Using the XXX Pulse Oximetry System
- Indications for Use
- General Information about Bluetooth Technology
- Installing the Battery Pack in the Display Unit
- Installing Batteries in the Pulse Oximeter Device (POD)
- Displays, Indicators, and Controls
- Setting Up the XXX System
- Verifying System Operation
- Device Pairing
- Default Settings
- Accessing User Functions
- Dislay Unit DIP switches
- Care and Maintenance
- Alarms and Limits
- Communication
- Specifications
- Parts and Accessories
- Service, Support, and Warranty
- Troubleshooting
28
Communication
Playing Back Memory Data
The XXX Pulse Oximetry System has a Memory Playback feature, allowing stored
data to be output through the RS232 serial connection.
1. With the display unit off, connect the RS-232 connector port of the display
unit to the back of your computer using a null modem cable.
2. With the display unit still off, press and hold the Memory button while
pressing the ON/STANDBY button.
• All LEDs will illuminate briefly. PLy bac will appear in the
SpO
2
and Pulse Rate LED display areas. This message signals that
the device is in Playback mode.
3. The PLy bAC message will disappear when memory playback is complete.
(Memory playback may take up to 8 minutes, depending upon the amount of
data.) Pressing the ON/STANDBY button will exit Playback mode.
4. A CLr no message will be displayed, and three informational tones will
sound.
5. (OPTIONAL): To clear the memory:
• Use the Plus or Minus buttons to select Clr YES.
• Press the ON/STANDBY button.
• To confirm the clearing of memory, use the Plus or Minus buttons
to select DEL YES.
• Press the ON/STANDBY button again.
• dnE CLr confirms that the memory is clear.
6. Press the ON/STANDBY button to return to normal operation.