User's Manual

15
System Components and Setup
X-100H (Hub)
The X-100H hub connects to the connector port on
the front of the monitor. The hub provides
connections for up to six X-100SP signal
processors via the hub ports. Each hub port has a
protective port cover.
For cleaning instructions, refer to "Care and
Maintenance" on page 67.
Connect/Disconnect the Hub
1. To connect:
a. Align the arrow on the hub cable connector
with the small triangle on the monitor
connector port.
b. Push the hub cable connector straight into
the port. The hub cable connector will click
when it locks into the monitor connector port.
2. To disconnect:
a. Grasp the retractable sleeve on the hub
cable connector.
b. Retract the sleeve and pull the hub cable connector straight back. The hub will unlock
and detach from the monitor.
CAUTION: Do not attempt to connect more
than one hub in the system.
CAUTION: Do not attempt to use an
extension cable between the monitor and
the hub.
Figure 4. X-100H – Hub
Table 4. X-100H Features
Number Description
1 Cable connector
2 Channel port
3 Port cover
!
!
DRAFT 10 DEC 2012
DRAFT 10 DEC 2012