User's Manual

System Components and Setup

Connect/Disconnect a Signal Processor to/from Hub or Monitor

1. To connect:

a. Align the arrow on the signal processor cable connector with the arrow on one of the

hub ports or the monitor connector port.

b. Push the signal processor cable connector into the port.

c. The signal processor cable connector will click when it locks into the hub or monitor.

2. To disconnect:

a. Grasp the ring on the X-100SP signal processor cable connector.

b. Retract the ring and pull the X-100SP connector straight back. The X-100SP will

unlock and detach from the hub or monitor.

NOTE: When removing the signal processor from the hub or the monitor, do not pull on the

signal processor cable.

NOTE: A signal processor can be connected to a hub port, or it can be connected directly to

the monitor. When a signal processor is connected directly to the monitor, an extension cable

may be used between the monitor and the signal processor.

Connect/Disconnect a Sensor to the Signal Processor

1. To connect:

a. Flip the clear sensor lock on the signal processor back to expose the sensor

connection port.

b. Insert the sensor connector into the signal processor connection port.

c. Flip the sensor lock over the sensor connector and click it into place.

2. To disconnect:

a. Flip the sensor lock back to disengage the sensor lock away from the sensor

connector.

b. Grasp the sensor connector and remove the connector from the signal processor.

DRAFT 10 DEC 2012