User's Manual

18
System Components and Setup
X-100EC (Extension Cable)
Extension cables are available in 1- or 2-meter lengths. An
extension cable may be used:
• Between the hub and a signal processor.
• Between the monitor and a signal processor.
For cleaning instructions, refer to "Care and Maintenance"
on page 67.
Cable Clips
Each extension cable is delivered with 18 cable clips (3 clips of each signal processor color).
Cable clips may be attached to each end of the extension cable and the middle.
rSO
2
and SpO
2
Sensors
See the Parts and Accessories List on the operator’s manual CD for a complete list of
compatible sensors. See the specific sensor IFU for instructions on connecting the sensor to
the system and applying the sensor to the patient.
Battery
Battery capacity: 7.2 V Li-ion battery pack, 2.4 Ah when charged with the Model X-100M
Operating life (fully charged battery): 3 hours minimum
Storage life: 20-day minimum
Recharge time to 90% capacity: 2.5 hours maximum
CAUTION: Do not attempt to use an extension cable
between the monitor and the hub.
CAUTION: Do not attempt to connect multiple
extension cables between the monitor and the hub or
between the hub and a signal processor.
CAUTIONS:
• Follow local, state and national governing ordinances and recycling instructions
regarding disposal or recycling of the device and device components, including
batteries.
• Use only Nonin-approved battery packs.
• Batteries are a fire hazard if damaged. Do not damage, mishandle, or
disassemble.
Figure 7. X-100EC –
Extension Cable
!
!
!
DRAFT 10 DEC 2012
DRAFT 10 DEC 2012