Installation Guide
Before you get started If you’ve installed light switches before and are comfortable with high voltage wiring, installing a Noon™ switch is easy. If not, we highly recommend hiring a professional installer. Guided installation Get a pro If you would like to be guided through the installation experience, we have just what you need online. Not comfortable with high-voltage wiring? Go to noonhome.com/install. Get a Noon-trained professional installer at noonhome.com/installers.
In the box Need to know Tools you’ll need 1-Switch wall plate & mounting plate* Noon™ replaces light switches Compatible bulbs and fixtures • Works as a single-pole or multi-way switch • All residential bulbs including: LED, incandescent, halogen, fluorescent and CFL bulbs; MLV and ELV fixtures • Multi-way configurations support up to four switches per circuit. Requires all Noon switches on the multi-way circuit.
Are you replacing a single-pole or multi-way switch? Remove the old switch and identify wires 1. Turn power off at the circuit breaker 2. Unscrew the old switch Single-pole switch One light switch that controls a light or set of lights. CONTINUE Confirm that the power is off from the switch. Use the Noon™ wall protector to prevent wall scuffing. 3. Label wires and disconnect old switch Multi-way switch Two or more light switches that control the same light or set of lights. STOP Turn to page 11.
Install Noon™ 1. Install the Noon mounting plate 2. Hang the Noon Base from the mounting plate Make sure the hooks are facing out and upwards. Look for the “Top” indicator. 1 To free up your hands for wiring, hang the Noon Base with the wires near the top on the mounting plate. NOTE: Noon wall and mounting plates are recommended, but not required. 7 2 5. Install the Noon Wall Plate Push the Noon Base into the switch box and press down into place.
Check installation 1. Turn power on at the circuit breaker 2. Click switch to turn lights on and off If lights do not turn on or off, visit noonhome.com/troubleshoot for help. You’re done with installation. Use the Noon App to complete setup. You can download the Noon App on your iOS or Android device.
Installing a multi-way switch Multi-way wiring diagram Noon switches work as 3-way or 4-way switches. They are wired in parallel. Ground and neutral wires are required. Use the multi-way wall stickers and wire labels in the box. Line Line/Load Line/Load Traveller Load Traveller Line/Load Line/Load 11 Traveller Line/Load For full multi-way installation instructions, go to noonhome.com/multiway. Traveller Line/Load Noon™ switches can replace multi-way switches.
Resources For guided installation, visit noonhome.com/install. To book a Noon-trained installer, visit noonhome.com/installers. For help troubleshooting your install, visit noonhome.com/troubleshoot. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.