Manual

ManualsBrandsNor-Lake ManualsRefrigeratorsCOLD WALL EVAPORATOR MILK COOLERS

03/13 004728 Rev. E

COLD WALL EVAPORATOR

MILK COOLERS

Installation, Operation and

Maintenance Instructions

TABLE OF CONTENTS

Inspection

Installation

General

Location

Electrical

General Operation

General Maintenance

Periodic Cleaning

Maintenance Service and Analysis Guide

Summary of content (4 pages)

PAGE 1
COLD WALL EVAPORATOR MILK COOLERS Installation, Operation and Maintenance Instructions TABLE OF CONTENTS Inspection 2 Installation General Location Electrical 2 2 2 2 General Operation General Maintenance 3 3 Periodic Cleaning 3 Maintenance Service and Analysis Guide 1 4 03/13 004728 Rev.
PAGE 2
INSPECTION When the equipment is received, all items should be carefully checked against the bill of lading to insure all crates and cartons have been received. All units should be inspected for concealed damage by uncrating the units immediately. If any damage is found, it should be reported to the carrier at once, and a claim should be filed with the carrier.
PAGE 3
GENERAL OPERATION The milk coolers are cooled entirely by convection as a result of copper coils completely encircling the perimeter of the storage compartment. During the refrigeration process, heat is removed through the evaporator tubing and expelled through the condensing unit. It is important that the flow of air through the side louvers is not restricted in order to ensure the condensing unit operates properly.
PAGE 4
MAINTENANCE SERVICE AND ANALYSIS GUIDE REFRIGERATION SYSTEMS - ALL MODELS MALFUNCTION POSSIBLE CAUSE SOLUTION Compressor will not start no hum 1. 2. 3. 4. 5. Service cord unplugged Fuse blown or removed Overload tripped Control stuck open Wiring incorrect 1. 2. 3. 4. 5. Plug in service cord Replace fuse Determine reasons and correct Repair or replace Check wiring against the diagram Compressor will not start hums but trips on overload protector 1. 2. 3. 4.