Specification Sheet

Type
Project
Catalog No.
Lamp/Wattage
Dimensions
6505 Gayhart St., Commerce, CA 90040
www.noralighting.com • Specifications subject to change without notice. © 2012
Phone: [phone] • FAX: [phone] • e-mail: [e-mail]
NHIOICD-2
IC Air-Tight LED Housing for 2" IOLITE
Source: LED
PRODUCT DESCRIPTION
New construction housing for use in insulated ceilings can be in direct contact with thermal
insulation. Rated for use with Iolite Series fixture
CONSTRUCTION
Housing
0.040" Aluminum shallow housing constructed of Aluminum with integral bar hangers
Air Flow Restriction
Meets requirments of Air tight (AT) <2CFM (cubic feet per minute) in accordance with ASTM-
283 Air-Tight requirements.
Bar Hangers
Two 13-3/4" to 24-1/2" adjustable bar hangers with captive nails are included on housing.
Bar hangers are parallel to junction box, but can be repositioned 90º perpendicular to junction
box if desired. "L" Shaped bar hanger foot to align to bottom of construction joist. A T-Bar
notch allow for easy installation in a suspended ceiling.
Junction Box
Prewired 25 cubic inch 0.064" thick galvanized steel, with seven 1/2" knockouts, four
Romex® pryouts, and snap on covers. All leads are #18AWG wire, the ground wire is
connected to the bottom, and quick connectors are supplied on all leads. Through branch
circuit wiring, (4-in, 4-out).
ELECTRICAL
Electronic
Thermally protected, single tap input voltage available in 120V 60Hz.
Operating Ambient Temperature: 122ºF (50ºC) Max.
Power Factor: >0.90
Amp: 300mA - 330mA, 350mA MAX
Voltage 120 or 277V as specified
Wattage 13-14W
DIMMING
LE3 - 120V Triac dimmer
LE4 - 120V 0-10V / 277V 0-10V dimmer
Page 1 of 1
Housings (Compatible with NIO-2 Series Trims)
NHIOICD-28LE3: 2" Iolite IC Air-Tight LED Dedicated Housing (120V Triac / ELV Dimming)
NHIOICD-28LE4: 2" Iolite IC Air-Tight LED Dedicated Housing (120V Triac / ELV or 0-10V / 277V 0-10V Dimming)
Housing Length: 12"
Housing Width: 7-5/8"
Housing Height: 4"
Cut-out: 3-2/16"
Labels and Listings
cULus for Wet Location
Meets or exceeds ASTM-283 Air-Tight Requirements
Washington State and California Approved
3"
Ceiling Cut-out
4"
12"
7- 5/8"