54VT-PRO-SP01 Case AFS Pro 300, 600, 700 Display Kit (Self-Propelled) Installation Manual
Printed in Canada Copyright 2010 by NORAC Systems International Inc. Reorder P/N: 54VT-PRO-SP01-INST Rev C (Case AFS PRO 300, 600, 700 (Self-Propelled Display Kit) NOTICE: NORAC Systems International Inc. reserves the right to improve products and their specifications without notice and without the requirement to update products sold previously. Every effort has been made to ensure the accuracy of the information contained in this manual.
Contents 1 INTRODUCTION ...................................................................................................... 2 1.1 VT Software Version..........................................................................................................................................................2 1.2 List of Parts ..........................................................................................................................................................................
1 Introduction The Case AFS Pro 300, 600, 700 Display Kit Manual is intended to be used in conjunction with the UC5 Spray Height Control Installation Manual. This manual provides instructions to interface the UC5 Control Module to the Case AFS Pro 300, 600 or 700 Display. For installation of the rest of the UC5 Spray Height Control System please refer to the sprayer specific manual provided with the kit. 1.
2 Technical Specifications CAN ICES-3(A)/NMB-3(A) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
3 Installation 3.1 CANbus Interface Installation 1. Securely mount the control module (E01) on the center boom at the rear of the sprayer. 2. Tee the CANbus interface cable (C40) in to the Case “Application” CANbus. The “Application” CANbus is a 3 pin Deutsch connector located on the center section of the boom at the rear of the sprayer. 3. Connect the Deutsch plug on cable C40 to the end of the control module with only one Deutsch connector. 4.
3.2 Switch Box Installation 1. Disconnect cable C20 (Thru 2 connector) from the Input Module (E03). Remove the wedge from the face of the 12 pin Deutsch plug. 2. Insert the Roll CW pin from C26 into position 3 of the 12 pin plug on C20. Insert the Roll CCW pin from C26 into position 4 of the 12 pin plug on C20. Insert the wedge back into the plug. Connect C20 to the Thru 2 connector on the Input Module. 3. Connect the 12 pin Deutsch plug on C26 to the OEM 3 connector on the input module.
4 Cable Drawings 4.
4.
4.
4.
4.
Appendix A: Alternate Configuration If your sprayer has European style slant control, you will need to reconfigure the switch box as shown below. This is only required for sprayer types which are driving the slant output from the Input Module.
Canada NORAC Systems International Inc. Phone: (+1) 306 664 6711 Toll Free: 1 800 667 3921 Shipping Address: 3702 Kinnear Place Saskatoon, SK S7P 0A6 United States NORAC, Inc. Phone: (+1) 952 224 4142 Toll Free: 1 866 306 6722 Shipping Address: 6667 West Old Shakopee Road, Suite 111 Bloomington, MN 55438 Europe NORAC Europe Phone: (+33) (0)4 26 47 04 42 Shipping Address: Rue de l’hermitage 01090 GUEREINS France www.norac.
