Owner's manual

NORDAC SK 200E Manual
18 BU 0240 GB
3 SK 200E displays and control
By combining different modules for display, control and parameterisation, the NORDAC SK 200E can be
easily adapted to various requirements.
Alphanumeric display and control modules (Illustration below) can be used for simple commissioning. For
more complex tasks, connection to a PC system and the use of Nord Con parameterisation software is
available.
As supplied, without additional options, the diagnostic LEDs are externally visible. These signal the actual
device status. 2 potentiometers and 8 DIP switches are provided in order to set the most important
parameters. In this minimal configuration no other adapted parameters are stored in the plug-in EEPROM.
The only exception is the data concerning operating hours, faults and fault circumstances. This data can be
stored in the EEPROM.


















SK200Emountedonmotor,topview SK200Enotfitted,viewfrominside
RJ12
LEDs
Potentiometers
Plug-in EEPROM
Æ
8x DIP switches
Æ
.
Parameterisation and display options: SK CSX-3H and SK PAR-3H