Manual

5 Parameterisation
BU 0260 GB Subject to technical amendments 71
Parameter
{Factory setting}
Setting value / Description / Note Device Supervisor
Parameter
set
P167
Life time factor
0 ... 255
{ 0 }
Factor for the monitoring of the master by the slave
(see objects 100D
(hex)
)
0 = "OFF"
P168 ... [-01]
...
... [-17]
Profile parameters
0 ... 3FFF
(hex)
{see table on right}
Parameter setting for the profile parameters (Velocity Mode of the drive profile DSP 402).
(see objects 6048
(hex)
and 6049
(hex)
, each Sub-index 1 - 2)
Acceleration and deceleration
This results in the unit: rpm/s
(achieved change in [rpm] divided by the time elapsed during the change in [s])
Array
[-01] = Profile:
0= "OFF"
1= "ON"
[-02] = ∆n for acceleration FI 1
[-03] = ∆t for acceleration FI 1
[-04] = ∆n for deceleration FI 1
[-05] = ∆t for deceleration FI 1
[-06] = ∆n for acceleration FI 2
[-07] = ∆t for acceleration FI 2
[-08] = ∆n for deceleration FI 2
[-09] = ∆t for deceleration FI 2
Factory setting
{ 0 }
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
Array
[-10] = ∆n for acceleration FI 3
[-11] = ∆t for acceleration FI 3
[-12] = ∆n for deceleration FI 3
[-13] = ∆t for deceleration FI 3
[-14] = ∆n for acceleration FI 4
[-15] = ∆t for acceleration FI 4
[-16] = ∆n for deceleration FI 4
[-17] = ∆t for deceleration FI 4
Factory setting
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
{ 1500 }
{ 2 }
Units: ∆n in [rpm]
∆t in [ms]