Owner's manual

6 Parameterisation

BU 0270 GB Subject to technical amendments 51

Parameter

{Factory setting}

Setting value / Description / Note Device Supervisor

Parameter

set

P514 CAN baud rate (system bus)

Setting of the transfer rate (transfer speed) via the system bus interface. All bus participants

must have the same baud rate setting.

0 = 10kBaud

1 = 20kBaud

2 = 50kBaud

3 = 100kBaud

4 = 125kBaud

5 = 250kBaud**

6 = 500kBaud

7 = 1Mbaud *

0 ... 7

{ 5 }**

*) Safe operation cannot be guaranteed

**) for communication with the bus module, the parameter must be left at the factory setting

(250kBaud) otherwise no communication is possible.

P515 ... [-01]

…

... [-03]

CAN address (system bus)

Setting of the system bus address.

0 ... 255 dec

{ all 32 dec}

or { all 20 hex}

… [-01] = Receive address for system bus

… [-02] = Broadcast – Receive address for system bus (slave)

… [-03] = Broadcast – Transmit address for system bus (master)

NOTE:

If up to four SK 200E are to be linked via the system bus, the addresses must be set as follows

FI 1 = 32, FI 2 = 34, FI 3 = 36, FI 4 = 38.

The system bus addresses should be set via the DIP switches 1/2 (Section 2.2.3).