Owner manual

Decentralised drive technology - from SK 300E to SK 200E
32 Migration Guide-GB-11.10.2012
4.3.2 Braking resistors (external braking resistors)
If the SK 300E which is to be replaced is not equipped with a braking resistor, in general an internal
brake resistor type SK BR14 must be provided for the SK 2xxE. However, if a braking resistor was
fitted on the SK 300E, for the SK 2xxE a corresponding braking resistor type SK BRE4 must be used
in place of the internal braking resistor SK BRI4.
SK 300E-…-B-(-C) SK BR3-… SK 2xxE-…-A-(-C) SK BRE4-… Part. No. [Ω] [W]
…370-323… to
…221-323…
… 82/200-TI 0/1
… 82/200-TI 0/2
…370-123… to
…111-123…
…2-100-200 275273105 100 200
…370-323… to
…221-323…
…2-200-200 275273108 200 200
…550-340… to
…151-340…
… 120/100-TI 0/1
… 120/100-TI 0/2
…550-340… to
…151-340…
…2-400-100 275273012 400 100
…221-340… to
…401-340…
… 82/200-TI 0/1
… 82/200-TI 0/2
…221-340… to
…401-340…
…2-200-200 275273108 200 200
Table 21: Assignment of external braking resistors for SK 2xxE compared with SK 300E
Resistor type
SK BR3-…
A B C D
… 120/100-TI 0/1 150 160 65 75
… 82/200-TI 0/1 255 160 65 75
… 120/100-TI 0/2 150 160 75 82
… 82/200-TI 0/2 255 160 75 82
All dimensions in [mm]
Table 22: Dimensions of external braking resistors for SK 300E
All dimensions in [mm]
Resistor type
SK BRE4-…
A B C
Fixing dimensions
d e
∅
…1-100-100
…1-200-100
…1-400-100
150 178 61 83 32 4.3
…2-100-200
…2-200-200
255 178 61 83 32 4.3
A
B
C
d
e
Table 23: Dimensions of external braking resistors for SK 2xxE