User Manual

11. M EN US | 55
BANK MSB
The Bank Select MSB (“Most Significant Byte”) Control Change
message may be necessary to define if addressing a unit with a large
number of internal banks. According to the MIDI standard it is defined as
CC# 0, and uses one byte of data for a total of 128 bank values.
Range: 0-127, Off (Default Off)
BANK LSB
The Bank Select LSB (“Least Significant Byte”) Control Change mes-
sage - defined as CC# 32 - uses one byte of data to address a total of
128 banks.
Range: 0-127, Off (Default Off)
PROGRAM NUMBER
The actual Program Change message consists of one byte of data for a
total of 128 program values.
Range: 0-127, Off (Default Off)
7 - CONTROL CHANGE SETTINGS A/B
CTRL (CONTROL)
The Control Change number should be defined according to the pa-
rameter on the external unit which should be addressed. Refer to the
documentation of the external unit to see which CC numbers apply for
which parameters.
Range: 0-119, Off (Default Off)
VALUE
Define this value according to the initial value which should be sent
when using the CC Send On Load feature.
Range: 0-127, Off (Default Off)
8 - VOLUME VALUE A/B
The Extern section can send MIDI Volume (CC#7) messages, allowing
you to control the level of an external device. The value defined in this
setting determines the initial value sent when using the Volume Send On
Load feature.
Range: 0-127 (Default 0)
9 - GLOBAL SOFT THRU
Incoming MIDI that matches the Global or Panel A/B channels can be
re-routed, going out on the Extern channel if the Extern section is active
on the current Program. This setting determines if this re-routing should
apply or not.
Range: Off (Default), On