User's Guide

Nordic ID Group | Joensuunkatu 7 | FI-24100 Salo |Finland
Office [phone] | Fax + 358 2 727 7720 | [e-mail] 17 / 33
2020-04-30
Nordic ID HH83 User Guide
Version 1.2
2D IMAGER
This section describes methods for configuring 2D imager of Nordic ID HH83. The 2D imager module in
use is Opticon MDI-4100 2D scan engine.
There are three different ways to configure the 2D imager that are
1. Using configuration barcode
2. Using Nordic ID RFID demo application
3. Configuring via NUR Accessory extension API
1.8.7.1. USING CONFIGURATION BARCODES
The easiest way to configure 2D imager is to read a configuration code with the 2D imager. Please use
Opticon’s online configuration tools to create a configuration barcode and print it onto paper. Then scan
the code with the 2D imager of Nordic ID HH83 and new settings will be set and saved automatically.
Quick Instructions to generate imager configuration barcodes:
1. Opticon’s online configuration tools: http://opticonfigure.opticon.com/
2. Select “Browse” in the left corner of the page
3. Select “Code options”
4. Select “Settings of readable codes”
5. Select “Enabling of readable codes”
6. Select a barcode from the list e.g. Code 39
7. Press “Add” button at the bottom
8. From right corner of the page, select “Barcode Type”: e.g. PDF417
9. You can adjust the size of the code from the “Barcode Size”
10. Select “Advanced” from the lower part of the right column
11. The “2D code” field indicates the corresponding configuration string.
Find example configuration barcodes below. More configuration barcodes can be found at APPENDIX 1.
1 - Enable 1D codes: Tri-Optic, Industrial 2 of 5, Code 39 and S-Code
2 - Disable 1D codes: Tri-Optic, Industrial 2 of 5, Code 39 and S-Code