User's Manual

©2006 Nordic ID Oy
Nordic ID PL3000 user manual, v. 2.6, October 2006 109
ThirdPartyConfi g
If the confi g named “ThirdPartyConfi g” is selected as the active confi g, then SCU works in tandem with WZC
for confi guration of all radio and security settings for the radio module. WZC must be used to defi ne the
following radio and security settings: SSID, Auth Type, EAP Type, and Encryption. The following SCU confi g
settings can be defi ned for the ThirdPartyConfi g confi g: Client Name, Power Save, Tx Power, Bit Rate, and
Radio Mode. Those SCU confi g settings, all SCU global settings, and the WZC settings are applied to the
radio when ThirdPartyConfi g is selected as the active confi g and a power cycle is performed.
Status Window
The Status window provides status information on the radio. Status items include IP address and MAC
address for the client radio, IP address and MAC address for the AP, signal strength, channel, transmit
power, and data rate. A sample Status window is shown in Figure 4 below:
Figure 4: Status window
Here are the highlights:
- Client info: Name of active confi g, client name, client IP address, and client MAC address
- AP info: AP name, AP IP address, and AP MAC address
- Signal strength, shown both graphically and numerically
- Other connection info: Channel, transmit power[4], and bit rate
One status item, the radio association state, is shown on both the Status window and the Main window.