Use and Care Manual

Blade is not flush to ground:
In the angled position, the blade will not be flush to the ground if the top pivot and bottom pivot plates are
reversed.
The blade flips forward when plowing:
Adjust the boots and axle so that the axle is 7” (178mm) from the ground. For Walk-Behind Z mowers,
you can also add a bolt above the axle to keep the plow from flipping forward at all; however this disables
the ability to raise the blade.
T-Handle Hard to Insert:
The top and bottom pivot bolt must be loosened to allow for some movement in the metal plates.
The blade is heavy to lift with foot pedal during operation:
This has occurred because snow, sand, dirt, etc. has accumulated on the blade. You should reverse the
machine to clear the blade of the material before lifting the blade with the foot pedal or strap if you have a
walk behind mower.