User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
Hardware description
Figure 19: External GPS antenna connector
The LNA enable signal is controlled by the logic circuitry. It is enabled only when the antenna tuning
circuitry is set to operate at the GPS frequency band. The LNA makes the GPS receiver more sensitive to
GPS signals and less sensitive to interference from other sources nearby.
Figure 20: GPS circuit schematic
Note: GPS signals do not usually penetrate ceilings or other structures. For best GPS performance,
Nordic Thingy:91 should be used outside in an open space, far from sources of interference and
other structures that may block the signals.
6.3.4 SIM card
Nordic Thingy:91 is equipped with a nano-SIM (4FF) card slot.
4418_1336 v1.2
26