User Manual

14
11. Tighten two #8 x 1" Pan Head Screws (98) into
the bottom of the console assembly (F) in the
location shown.
11
98
F
10. Insert the Upright Wire (81) through the two
indicated looped ties (I) on the console assembly
(F).
Connect the Upright Wire (81) to the con-
sole wire (J). The connectors should slide
together easily and snap into place. If they
do not, turn one connector and try again. IF
YOU DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER. Then, remove the wire tie from the
Upright Wire.
10
I
I
J
F
81