Owner's Manual

11. Make sure that all parts are properly tightened before you use the incline trainer. Keep the included hex

keys in a secure place. One of the hex keys is used to adjust the walking belt (see pages 29 and 30). To pro-

tect the floor or carpet from damage, place a mat under the incline trainer.

106

110

10. See page 14 and plug in the power cord. Next,

see page 16 and turn on the power. Then, touch

the 1 Step Incline button numbered 40 on the

console. The Frame (58) will adjust to an incline

of 40 percent. Then, unplug the power cord.

Identify the Left Inside Cover (110) and the Left

Outside Cover (106). Next, hold the Left Inside

Cover against the left Upright (77). Then, hold

the Left Ouside Cover against the Left Inside

Cover.

Attach the Left Outside Cover (106) to the Left

Inside Cover (110) with a #8 x 1 1/4" Screw (36)

and two #8 x 3/4" Screws (1). Start all three

Screws and then tighten them.

Attach the Right Inside Cover and the Right

Outside Cover (not shown) as described

above.