Owner's Manual

11
10. With the help of a second person, hold the con-
sole assembly near the Right Handrail (79) and
the Left Handrail (not shown).
Connect the Upright Wire (85) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN YOU TURN ON THE
POWER. Remove the wire tie from the Upright
Wire.
Console
Assembly
10
Console
Wire
Wire
Tie
79
85
85
Console
Wire
9. Hold the Right Handrail (79) near the Right
Upright (83). Insert the Upright Wire (85)
through the Right Handrail as shown. Slide a
H
andrail Cover (77) onto the lower end of the
Right Handrail. Remove the tie from the bracket
o
n the Right Handrail.
Insert the bracket on the Right handrail (79) into
the top of the Right Upright (83) and at the same
time slide the lower end of the Right Handrail
onto the tube on the Right Upright.
Start two 5/16" x 3/4" Patch Bolts (5) and two
5/16" Star Washers (9) into the Right Upright
(83) and the Right Handrail (79). Then, start a
5/16" x 1 1/2" Patch Bolt (4). Do not tighten the
Patch Bolts yet. Be careful not to pinch the
Upright Wire (85).
Start two 1/4" x 1/2" Patch Bolts (8) into the
lower end of the Right Handrail (79). Tighten all
five Patch Bolts used in this assembly step.
Slide the Handrail Cover (77) against the Right
Upright (83).
79
9
5
8
4
83
85
77
9
Tie