Owner's Manual

14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic

on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.

Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is

used to adjust the walking belt (see pages 26 and 27).

13. Turn on the power (see page 16). See step 4 on

page 17 and lower the incline to the lowest posi-

tion. Then, remove the key from the console,

press the power switch into the off position, and

nplug the power cord.

Raise the Frame (55) to the position shown.

Have a second person hold the Frame until

his step is completed.

Orient the Storage Latch (51) so that the large

barrel and the latch knob are oriented as shown.

Remove the tie from the upper end of the

Storage Latch (51). Attach the upper end of the

Storage Latch to the Frame (55) with a 3/8" x 1

3/4" Patch Bolt (6).

Remove the tie from the lower end of the

Storage Latch (51). Keep the holes in the latch

cap aligned with the holes in the Storage Latch.

Make sure to keep the latch cap inside the

Storage Latch. Attach the Storage Latch to the

Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" Nut

(10). Note: It may be necessary to move the

Frame (55) back and forth to align the Storage

Latch with the Base.

Lower the Frame (55) (see HOW TO LOWER

THE TREADMILL FOR USE on page 24).

Large

Barrel

Latch Knob

Latch

Cap