Owner's Manual

18
4. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
I
ncline increase or decrease button or one of the
numbered 1 Step Incline buttons. Each time you
p
ress one of the buttons, the treadmill will gradu-
ally adjust to the selected incline setting.
5. Follow your progress with the displays.
As you walk or run on the treadmill, the display can
show the following workout information:
The elapsed time
The distance that you have walked or run
The matrix
The workout intensity bar
The approximate number of calories you have
burned
The incline level of the treadmill
The number of vertical feet you have climbed
The speed of the walking belt
Your heart rate (see step 6 on page 19)
The matrix offers several display tabs. Press the
increase and decrease button next to the Enter
button until the desired tab is shown.
The Incline tab will show a profile of the incline set-
tings of the workout. A new segment will appear at
the end of each minute. The Speed tab will show a
profile of the speed settings of the workout.
The My Trail tab will show a track that represents
1/4 mile (400 meters). As you exercise, the white
rectangle will show your progress. The My Trail tab
w
ill also show the number of laps you are complet-
ing.
The Calorie tab will show the approximate amount
of calories you have burned. The height of each
segment represents the amount of calories burned
during that segment. When the Calorie tab is se-
lected, the calorie display will show the approxi-
mate number of calories burned per hour.
As you exercise, the workout intensity level bar will
indicate the approximate intensity level of your ex-
ercise.
Press the Home button to return to the default
menu (see THE INFORMATION MODE on page
23 to set the default menu). If necessary, press the
Home button again.
When an iFit Live module is
connected, the wireless sym-
bol at the top of the display
will show the strength of your
wireless signal. Four arcs in-
dicate full signal strength.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.