Owner's Manual

9
8. With the help of a second person, hold the
handrail assembly near the Left Upright (89).
Connect the Upright Wire (84) to the Handrail
Wire (86). See the inset drawing. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie
from the Upright Wire.
Handrail
Assembly
Wire
Tie
89
84
86
84
86
8
7. Remove the four 3/8" x 1" Screws (2) from the
Uprights (89, 90).
Orient each Handrail Bracket (85) so that the
l
ong tab is in the position shown and the large
holes are on top. Route the Upright Wire (84)
through the center hole in a Handrail Bracket.
A
ttach each Handrail Bracket (85) with the two
3/8" x 1" Screws (2) and two 3/8" Star Washers
(12). Start all four Screws, and then tighten
each of them.
2
12
85
84
2
Long
T
ab
Large
Holes
12
85
L
ong
Tab
7
89
90