Owners manual

13
8
8. Set the console assembly (F) face down on a
soft surface to avoid scratching the console
assembly. Remove and save the four 1/4" x
1/2" Screws (4).
4
F
4
9
F
93
86
27
4
4
27
H
H
G
G
9. Hold the console assembly (F) near the Pulse
Crossbar (93).
See the inset drawing. Connect the pulse wires
(G, H). The connectors should slide together
easily and snap into place. If they do not, turn
one connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER.
Next, insert the two pulse wires (G, H) into the
console assembly (F) as you set the console
assembly onto the brackets on the Handrails
(86); do not pinch any wires.
Attach the console assembly (F) with the four
1/4" x 1/2" Screws (4) that you removed in step
8 and four 1/4" Star Washers (27); do not fully
tighten the Screws yet.
86