7200 R User's Manual

6. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen

wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 29). To protect the

floor or carpet from damage, place a mat under the treadmill.

5. Insert two Handrail Bolts (104) with Handrail Spacers

(106) into the right Upright (99) and the right Handrail

(83). Be careful not to pinch the wires. Make sure

that the Handrail Spacers are flush against the right

Upright, with the thick sides facing the center of the

treadmill, as shown in the inset drawing. Next, lift the

right Handrail (83) slightly and align the Bolts with the

holes in the Handrail. Thread the Bolts into the

Handrail. Do not tighten the Bolts yet.

Attach the left Handrail (not shown) in the same way.

Then, tighten all four Handrail Bolts (104).

104

106

Thick

Side

106

4. Cut the plastic tie holding the Upright Wire Harness (119)

in the right Upright (99). Have a second person hold the

Handrails (83) near the Uprights. Connect the Upright

Wire Harness to the wires extending from the Console

Base (130). The connectors should slide together

easily and snap into place. If they do not, turn one

connector and try again. Then, insert the connectors

and the Upright Wire Harness into the hole in the right

Upright.

Set the Handrails on the Uprights, being careful not to

pinch the wires.

119

130