Owner's Manual

10
1. Make sure that the power cord is unplugged.
Remove the indicated 3/4" Screws (4) from the
Pulse Receiver Cover (70) on the back of the
console assembly.
2. Next, hold the receiver so the small cylinder
is oriented as shown. Attach the receiver to the
Pulse Receiver Cover (70) with the two included
small screws.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Reattach the Pulse
Receiver Cover (70) to the Console Assembly
with the two 3/4" Screws (4). Discard the other
wires included with the receiver.
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
Console
Assembly
1
70
4
Console
Assembly
3
70
Wires
Tab
4
70
Cylinder
2
Small Screws
Receiver
Reveiver