Owner's Manual

4. With the help of a second person, hold the con-

sole assembly near the Uprights (73, 74).

onnect the Upright Wire (75) to the Console

Wire Harness (71). See the inset drawing. The

onnectors should slide together easily and

snap into place. If they do not, turn one con-

nector and try again. IF THE CONNECTORS

ARE NOT CONNECTED PROPERLY, THE

CONSOLE MAY BE DAMAGED WHEN THE

POWER IS TURNED ON.

Remove the tie from the Upright Wire (75).

Console

ssembly

Tie

5. Insert the brackets on the Handrails (99) into the

Uprights (73, 74). Make sure that no wires are

pinched.

6. Finger tighten three Handrail Bolts (64) with

three Upright Star Washers (90) into the Right

Upright (74). Next, finger tighten three Handrail

Bolts with three Upright Star Washers (not

shown) into the Left Upright (73). Then, firmly

tighten the six Handrail Bolts.