Manual

rate setting for the
current segment,
The Htindicators TRAINING ZONES
in the bar wHU F--_BU--_NE_xNP-_:--
show your actuaU
pace, When you
hoUdthe handgrip
pube sensor or
wear the optionaU
chest puUsesen-
sor, the consob e o o
ENDURANCE
wHUperiodbaHy
compare your
heart rate to the
target heart rate setting for the current segment;
if necessary, an indicator in the bar wHUthen flash
to prompt you to increase or decrease your pace
to bring your heart rate closer to the target heart
rate setting, ff an indicator to the rightof the Ht
indicators is flashing (see drawing a), increase
your pace, ff an indicator to the leftof any Htindi-
cator is flashing (see drawing b), decrease your
pace, When no indicator is flashing, your heart
rate is near the target heart rate setting,
Important: The target heart rate settings are
intended only to provide motivation. Your
actuaJ heart rate may be slower than the tar-
get heart rate settings. Make sure to exercise
at a pace that is comfortable for you.
Note: During the program, you can override the
resistance setting, if desired, by pressing the
Resistance buttons, However, when the next
segment begins, the resistance will change if a
different resistance setting is programmed for the
next segment,
The program wili continue until the last segment
ends,
if you stop pedaling for several seconds, a tone
will sound and the program will end, Heart rate
programs cannot be stopped temporarily and
then restarted,
Monitor your progress with the two displays.
See step 4 on page 12,
Turn on the fan if desired.
See step 6 on page 13,
When the program is finished, the consote
wilt automatically turn off.
See step 7 on page 13,
16