Owner's Manual

Inspect and tighten all parts of the elliptical exerciser

egularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and

a small amount of mild soap. IMPORTANT: To avoid

amage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

CONSOLE TROUBLESHOOTING

If the console does not display your heart rate when

you hold the handgrip pulse sensor, or if the displayed

heart rate appears to be too high or too low, see step

6 on page 18.

HOW TO LEVEL THE ELLIPTICAL EXERCISER

If the elliptical exerciser rocks slightly on your floor

during use, see HOW TO LEVEL THE ELLIPTICAL

EXERCISER on page 12.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. First, remove all of

the screws from the left outer and inner shields; there

re two sizes of screws in the left outer and inner

shields—note which size of screw you remove

from each hole. Then, gently remove the left outer

shield.

Next, locate the Reed Switch (86). Turn the Pulley

(53) until a Magnet (88) is aligned with the Reed

Switch. Loosen, but do not remove, the indicated M4 x

16mm Screw (67). Slide the Reed Switch slightly clos-

er to or away from the Magnet, and then retighten the

Screw. Rock the Pulley forward and backward just

enough that the Magnet passes the Reed Switch

repeatedly. Repeat until the console displays correct

feedback. When the Reed Switch is correctly adjusted,

reattach the left outer and inner shields. Note: If you

have questions regarding which screw should be in

which hole, see EXPLODED DRAWING A on page 25

and the PART LIST on page 24.

MAINTENANCE AND TROUBLESHOOTING