Owner's Manual

8
6b
6a
6. See drawing 6a. Locate the Pedal Arm Roller
(32) on the Right Pedal Arm (12). Set the Pedal
Arm Roller on the Ramp (130).
Repeat this step on the other side of the
elliptical.
See drawing 6b. Apply grease to the axle on
the right Crank Arm (39).
Orient a Pedal Arm Sleeve (46) so that the flat
side is facing the elliptical. Slide the Pedal Arm
Sleeve onto the axle on the right Crank Arm
(39). Attach the Pedal Arm Sleeve with an M8 x
25mm Patch Screw (121), a Large Axle Cover
(113), and an M8 Washer (95).
Next, pull upward on the Latch (50) on the Right
Pedal Arm (12). Press the Right Pedal Arm onto
the Pedal Arm Sleeve (46). Make sure that the
Right Pedal Arm latches into place.
Repeat this step on the other side of the
elliptical.
5. Identify the Right Pedal (14), the Right Gel
Cushion (55), and the Right Pedal Arm (12),
which are marked with “Right” stickers, and ori-
ent them as shown.
Set the Right Gel Cushion (55) on the Right
Pedal Arm (12). Then, set the Right Pedal (14)
on the Right Gel Cushion.
Attach the Right Pedal (14) to the Right Pedal
Arm (12) with two M6 x 50mm Patch Screws
(62), two M6 x 12mm Patch Screws (111), and
four M6 Washers (112).
Attach the Left Pedal (not shown) and the
Left Gel Cushion (not shown) to the Left
Pedal Arm (not shown) in the same way.
5
1
4
12
112
32
12
95
113
46
Flat
Side
12
112
130
62
5
5
111
111
39
Grease
50
121