Owner's Manual

ManualsBrandsNordicTrack ManualsHome GymsNordicTrack NTEL091096

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damag-

ing the console, keep liquids away from the

console and keep the console out of direct

sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the

power cord is fully plugged in. If lines appear in the

console display, see HOW TO USE THE INFORMA-

TION MODE on page 18 and adjust the contrast level

of the display.

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low,

see step 5 on page 16.

HOW TO CALIBRATE THE RAMP

If the ramp is not functioning properly, the ramp may

need to be calibrated. To calibrate the ramp, press

and hold the Target Toning Workouts button for sev-

eral seconds until the calibration mode appears in the

display.

Press the Target Toning Workouts button once. The

ramp calibration instructions will appear in the display.

Press the 1 Step Power Ramp Increase or Decrease

button to calibrate the ramp. The ramp will move

upward and downward as it calibrates.

When the ramp stops moving, the ramp is calibrated.

Then, press the Target Toning Workouts button repeat-

edly to exit the calibration mode.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, first unplug the power cord.

Using a flat screwdriver, release the tabs on the

Access Cover (20) and pull the Access Cover upward

off the elliptical.

Next, look into the access opening and locate the

Reed Switch (69). Rotate the Large Pulley (74) until a

Pulley Magnet (75) is aligned with the Reed Switch.

Next, loosen, but do not remove, the indicated M4 x

16mm Screw (106). Slide the Reed Switch (69)

slightly toward or away from the Pulley Magnet (75).

Then, retighten the M4 x 16mm Screw.

Plug in the power cord and rotate the large pulley for a

moment. Repeat these actions until the console dis-

plays correct feedback. When the reed switch is

correctly adjusted, reattach the access cover.

MAINTENANCE AND TROUBLESHOOTING

106