Owner's Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the

packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tool(s) and your own Phillips screwdriver , adjustable

wrench , and rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-

ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The

number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware

kit, check to see if it has been preassembled.

#8 x 3/4"

Screw (78)–4

5/16" x 1" Patch

Screw (81)–11

#10 x 1/2"

Screw (79)–10

5/16" x 1.5" Button

Bolt (73)–4

5/16" Washer

(104)–6

#10 Fender

Washer (80)–10

5/8" Wave

Washer (102)–6

5/16" Split

Washer (105)–5

5/16" Locknut

(106)–4

M10 x 20mm Patch

Screw (108)–6

Pivot Spacer

(71)–4

5/16" x 2 1/2" Button

Screw (88)–8

M10 Split

Washer (110)–6

M6 Split

Washer

(111)–10