Owner's Manual

9
7
. While a second person holds the Console (60)
near the Upright (6), connect the console wire
to the Upper Wire Harness (97). Then, connect
the console pulse wire to the Hand Pulse Wire
(65). Insert the excess wire downward into the
Upright.
Tip: Avoid pinching the wires during this
step. Attach the Console (60) to the Upright (6)
with four #8 x 3/4" Screws (78).
7
Avoid pinching
the wires
Pulse
Wire
6
Console
Wire
65
97
78
60
9. Plug the Power Cord (55) into the power socket
at the rear of the elliptical exerciser (see HOW
TO PLUG IN THE POWER CORD on page 10).
IMPORTANT: If the elliptical exerciser has
been exposed to cold temperatures, allow it
to warm to room temperature before plug-
ging in the power cord. If you do not do this,
the console displays or other electronic
components may become damaged.
Note: When you plug in the elliptical exer-
ciser for the first time (see HOW TO PLUG IN
THE POWER CORD on page 10), the Ramp
(not shown) will calibrate automatically. The
Ramp will move upward and downward as it
calibrates. When the Ramp stops moving, the
Ramp is calibrated.
IMPORTANT: If the Ramp (not shown) does
not calibrate automatically, see HOW TO
CALIBRATE THE RAMP on page 20 and
manually calibrate the Ramp.
9
8. Identify the Right Handlebar (31), which is
marked with a “Right” sticker and orient it as
shown. Attach the Right Handlebar to the right
Upper Body Arm (12) with two 5/16" x 1.5"
Button Bolts (73) and two 5/16" Locknuts (106).
Make sure that the Locknuts are in the
hexagonal holes.
Repeat this step to attach the Left Handlebar
(7) to the left Upper Body Arm (12).
8
31
106
73
7
12
55
12
10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Hexagonal
Holes