User Manual

HOW TO ADJUST THE LEFT CRANK ARM

If the Left Crank Arm (21) feels loose while you are

pedaling, first loosen the two M6 x 25mm Screws (96).

Then, follow the steps below. Note: If you have a

torque wrench, tighten the Screws (15, 96) to the listed

torque specs. If you do not have a torque wrench, sim-

ply tighten the Screws as firmly as you can.

1. Tighten the M12 Crank Screw (15) to 7 Nm

(5 ft-lbs).

2. Tighten each M6 x 25mm Screw (96) to 20 Nm

(15 ft-lbs). Then tighten each M6 x 25mm Screw a

second time to 20 Nm (15 ft-lbs) in the same order.

3. Finally, tighten the M12 Crank Screw (15) to 50 Nm

(37 ft-lbs).

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, first unplug the power

adapter. Next, remove the three indicated #8 x 5/8"

Screws (152) from the Right and Left Shields (30, 32).

Then, carefully pull the tops of the Right and Left

Shields (30, 32) apart a few inches.

See the inset drawing. Slightly loosen the two indi-

cated #8 x 1/2" Screws (57). Next, rotate the Left

Crank Arm (21) until a Pulley Magnet (137) is aligned

with the Reed Switch (115). Slide the Reed Switch

slightly toward or away from the Pulley Magnet. Then,

retighten the Screws.

Plug in the power adapter and rotate the Left Crank

Arm (21) for a moment. Repeat these actions until the

console displays correct feedback.

When the reed switch is correctly adjusted, reattach

the Right and Left Shields (30, 32).

152

115

137

115