Manual

HOW TO FOLD AND MOVE THE iNCLiNE TRAINER

HOW TO FOLD THE mNCLmNETRAmNER FOR STORAGE

Before folding the incline trainer, adiuat the incline to the

towest position, mfthis is not done, the incline trainer may

be permanently damaged. Remove the key and unptug the

power cord. CAUTmON: You must be able to safely lift 45

pounds (20 kg) to raise, tower, or move the incline

trainer.

1, HoUdthe incline trainer with your hands in the bcation

shown by the arrow at the right, CAUTION: To decrease

the possibility of injury, bend your tegs and keep your

back straight. As you raise the incline trainer, make

sure to tift with your tegs rather than your back. Raise

the incline trainer about halfway to the vertical position,

2, Move your right hand to the position shown and hold the

incline trainer firmly, Using your left hand, pull the latch

knob to the left and hold it, Raise the incline trainer until

the latch pin is aligned with the indicated hole in the catch,

Insert the latch pin into the hole, Make sure that the

tatch pin is fully inserted into the hote.

To protect the floor or carpet from damage, pJace a

mat under the incline trainer. Keep the incline trainer

out of direct sunlight. Do not teave the incline trainer

in the storage position in temperatures above 85°

Fahrenheit.

HOW TO MOVE THE INCLINE TRAINER

Before moving the incline trainer, convert the incline trainer

to the storage position as described above, Make sure that

the latch pin is fully inserted into the hote in the side of

the incline trainer.

1, Hold the handrails as shown and place one foot against a

wheel,

2, Tilt the incline trainer back until it rolls freely on the wheels,

Carefully move the incline trainer to the desired location,

Never move the incline trainer without tipping it back.

To reduce the risk of injury, use extreme caution

while moving the incline trainer. Do not attempt to

move the incline trainer over an uneven surface.

3, Place one foot against a wheel, and carefully lower the in-

cline trainer until it is resting in the storage position,

Base